NORDAC SK 5xxE Manual
120
Subject to technical alterations
BU 0500 GB
Parameter
Set value / Description / Note
Device
Supervisor
Parameter
set
P748
... - 01
…
... - 03
Status CANopen
SK 520E
and above
S
[01] =
CANbus/CANopen Status
[02] =
reserved
[03] =
reserved
Bit 0 = 24V Bus supply voltage
Bit 1 = CANbus in status “Bus Warning”
Bit 2 = CANbus in status “Bus Off”
Bit 3 ... 5 = free
Bit 6 = Protocol of the CAN module is
0 = CAN or 1 = CANopen
Bit 7 = free
Bit 8 = „Bootsup Message“ sent
Bit 9 = CANopen NMT State
Bit 10 = CANopen NMT State
Bit 11 = free
Bit 12 ... 14 = reserved
Bit 15 = free
CANopen NMT State
Bit 10
Bit 9
Stopped =
Pre-Operational =
Operational =
0
1
1
1
0
1
0000 ... FFFF (hex)
P750 Overcurrent
statistic
S
0 ... 9999
Number of overcurrent messages during the operating period P714.
P751
Over voltage statistic
S
0 ... 9999
Number of overvoltage messages during the operating period P714.
P752
Mains supply faults
S
0 ... 9999
Number of mains faults during the operating period P714.
P753 Overheating
statistics
S
0 ... 9999
Number of overtemperature faults during the operating period P714.
P754
Parameter loss statistic
S
0 ... 9999
Number of parameters lost during the operating period P714.
P755
System faults statistic
S
0 ... 9999
Number of system faults during the operating period P714.
P756
Time out statistics
S
0 ... 9999
Number of Time out errors during the operating period P714.
P757
Customer faults statistic
S
0 ... 9999
Number of Customer Watchdog faults during the operating period P714.
P799
... - 01
...
... - 05
Operating hours, latest fault 1…5
0.1 ... ___ h
This parameter shows the operating hours counter status (P714) at the moment of the previous
fault. Array 01…05 corresponds to the lastest fault 1…5.
