1 General information
BU 0280 GB
Subject to technical amendments
9
1.1 Overview
Features of DeviceNet modules
Electrically isolated bus interface
Transfer rate up to 500 kBaud
Easy connection of the frequency inverter, optionally via M12 round plugs or screw terminals
Looping of the DeviceNet via the modules is possible
Integrated bus termination resistor
DeviceNet-specific
status display with 2 LEDs
Module or FI-specific status display with 2 LEDs
Up to four 24V inputs and two 24V outputs are integrated into the bus module
Direct connection of up to 4 sensors and 2 activators via M12 round plug connectors on the SK TU4-
DEV-M12(-C) version. Visualisation of signal status via LEDs
DeviceNet gateway solution
→
up to 4 frequency inverters can be connected to a DeviceNet module
Up to 64 DeviceNet modules can be connected to the bus, so that it is possible to operate up to 256
frequency inverters on a single bus.
Interface (RS232/RS485) for parameter access by means of the SK CSX-3H or SK PAR-3H manual
control unit or NordCon software via RJ12 connector (Except for SK CU4-DEV. Here parameter
access via the SK 200E frequency inverter is possible)
Available as versions for installation in the inverter (IP20) or in a separate housing (optionally IP55 / IP66)
1.2 Delivery
Check the equipment
immediately
after delivery/unpacking for transport damage such as deformation or
loose parts.
If there is any damage, contact the carrier immediately and implement a thorough assessment.
Important! This also applies even if the packaging is undamaged.
1.3 Scope of supply
Standard version:
SK CU4-DEV
IP20
or
SK TU4-DEV(-M12)(-C)
IP55,
(optionally IP66)
Operating instructions as PDF file on CD ROM including NORD CON, (Windows PC-
based parameterisation software)
