19
Figure 22 – Roll Sensor Mounting with Respect to Sprayer Orientation
4.7.1 Boom Roll Sensor Mounting
The boom roll sensor (
E04
) must be
mounted to the rotating part of the boom.
Follow these guidelines and refer to
Figure 23
to mount the sensor.
a)
Make sure you are using the roll
sensor that does NOT have a
temperature probe (only one cable)
(
E04
).
b)
The boom roll sensor must be
mounted to the rotating part of the
boom suspension.
c)
Use cable-ties to secure the bracket
to a square edge feature (square
tube).
d)
Ensure the AMP (circular)
connector exits towards the Right
Hand Wing (when looking from the
rear of the sprayer).
e)
Securely cable-tie the connector to
the frame.
4.7.2 Chassis Roll Sensor Mounting
The chassis roll sensor must be mounted
to a non-rotating part of the boom. To
mount the chassis roll sensor, follow the
following guidelines and refer to
Figure
23
.
a)
Make sure you are mounting the roll
sensor that does have a temperature
probe (2 cables) (
E03
).
b)
Mount the chassis roll sensor (
E03
)
to a non-rotating part of the boom.
c)
Cable-tie the bracket to a square
edge feature (square tube).
d)
The AMP (circular) connector
MUST
exit towards the Right Hand
Wing (when looking from the rear).
e)
Securely cable-tie the connector to
the frame.
* The boom frame
roll sensor does not
have a temperature
probe
Summary of Contents for Gregson Maverick 120 Series
