18
4.7 R
OLL
S
ENSOR
I
NSTALLATION
(C
ENTER
P
IVOT
S
TYLE
B
OOMS
)
Mount the roll sensors to the included roll
sensor brackets using the machine screws
and nylon lock nuts. (
Figure 20
)
The roll sensors must be mounted
tightly to the brackets.
Figure 20 – Mounting the Roll Sensor to the
Roll Sensor Mounting Bracket
When mounting the roll sensors use the
following guidelines and refer to
Figure 21
.
a)
The smaller the distance between
A
and
B
in
Figure 21
, the better the
performance will be.
Distance A can not be more than 12”.
b)
The roll sensors must not be mounted
below the pivot point.
c)
Ensure the roll sensors are sitting
relatively level when the sprayer chassis
and boom are level.
d)
Both roll sensors must be mounted with
the circular AMP connector facing
towards the Right-Hand Wing (when
looking from the rear of the sprayer).
Figure 21 – Mounting Guidelines for Center Pivot Sprayers
Connectors towards
Right-hand Wing
Æ
Summary of Contents for Gregson Maverick 120 Series
