Norac Gregson Maverick 120 Series, Installation Manual, Page: 30 / 36

28
11. Connect the CAN Node cable ( C02B ) to
the 4-pin AMP plug on C11 .
12. Route the CAN Node cable ( C02B ) to
the roll sensors which are installed in
Section 1.1 . Follow existing cables
and/or hydraulic lines.
13. Connect 4-pin AMP connectors on
C02B to the sensors.
14. Connect the sensor branch cable ( C02 )
to the 4-pin AMP plug on C02B ( Figure
34 ).
15. Route the sensor branch cable ( C02 ) to
the wing and main sensors and connect
to the sensors. Follow existing cables
and/or hydraulic lines along the boom.
16. Cable-tie the installed cables every 12
inches.
IMPORTANT:
Provide enough slack in all cables to
account for the movement of the main
section, parallel lift, and FOLDING boom
movement.
4.10 C
OMPLETING THE
I
NSTALLATION
1. Start up your sprayer and test the
sprayer’s functionality. The NORAC
Control Panel does not need to be
powered up for the original switches to
function. Unfold the booms and
raise/lower each boom and main section.
Confirm that the cabling/hoses are
agreeable to the entire range of
motion.
2. If any functions do not work, review the
hydraulic and electrical portions of this
manual to check for proper installation.
If you still have trouble, contact
NORAC for assistance.
3. Turn on the power for the UC4+ Control
Panel using the switch on the side of its
chassis.
4. Repeat the Boom Speed Test as
described in Section
4.2 Boom Speed
Test with the NORAC UC4+ Spray
Height Control system installed. Record
the results for comparison in
Table 5 .
5. The procedure for the installation of the
UC4+ Spray Height Control system is
now complete. Begin the AUTOMATIC
SYSTEM SETUP procedure as
described in the
UC4+ Spray Height
Control Operator’s Manual ( M01A ).