OPERATION
Falcon
t
Ultra B (07--05)
10
WHILE OPERATING MACHINE
WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
1. Periodically check for foam buildup in recovery
tank
(look through clear lid)
. If excessive foam
buildup begins to develop, pour a recommended
foam control solution into recovery tank.
ATTENTION: Do not allow foam to enter the float
shut-off screen, vacuum motor damage will result.
Foam will not activate the float shut-off screen.
2. Always operate at a slower speed when cleaning
around walls or obstacles.
3. Always reduce speed to maintain control when
turning machine.
4. Overlap each pass by 50 mm (2 in).
5. Before reaching end of cleaning path, turn off
pump switch and continue to drive machine
forward to extract solution.
6. Periodically check battery meter discharge level.
When needle drops to the red zone, recharge
batteries.
ATTENTION: Do not continue to run machine
when battery meter needle is in the red zone,
battery damage will result.
7. While cleaning, view clear hose gallon marker for
remaining cleaning solution. Each mark on hose
indicates 19 L (5 gal).
8. When solution tank runs dry, turn off pump and
vacuum switches, raise brush, and transport
machine to draining area (See DRAINING
TANKS)
.
9. If the cleaning path leaves streaks, spray tip
cleaning is required (See MONTHLY
MAINTENANCE)
.
CIRCUIT BREAKERS
The machine is equipped with two resetable circuit
breakers, Main (15A) and Vacuum/Drive (60A), to
protect machine from damage. If a circuit breaker
should trip during operation, determine the cause,
allow motor to cool and then manually reset the
breaker button. The circuit breaker panel is located at
rear of machine (Figure 9).
The vacuum/drive circuit breaker (60A) is designed to
stop current flow by manually pulling out the circuit
breaker button. This allows you to keep the machine
stationary while performing specific maintenance
procedures.
FIG. 9
Contact an Authorized Service Center for machine
repairs.
FOR SAFETY: When servicing machine, all repairs
must be performed by a qualified service person.
OPTIONAL ACCESSORY TOOL SETUP
AND OPERATION
Machine is equipped with accessory tool connections.
Accessory tool enables you to reach areas that the
machine is unable, such as alcoves, stairs and corners
(See Options).
1. Vacuum area before cleaning.
2. Fill solution tank and add cleaning chemical (See
FILLING SOLUTION TANK)
.
WARNING: Fire or Explosion Hazard. Never
Use Flammable Liquids.
3. Disconnect lower vacuum hose at rear of machine
and replace with accessory vacuum hose
(Figure 10).
FIG. 10
