Noblelift RT16P, Service Maintenance Manual

Page: 21 / 50

19
LIFT LOADS ALLOWED IN LOAD CURVE DIAGRAM ONLY OR DAMAGE THE TRUCK.
Push backwards the lifting control stick (7) until reach the desired lifting height.
When the lifting height without load is more than 3m or the lifting height with load is more
than 1m, please reduce the speed of truck. Be careful of operation when steer the truck, do
not sharply start, stop or steer the truck.
Be cautious in lifting work in the shelf area, pay attention to the gap between the goods and
the shelf.
h.
Lowering
If the forks are in the racking, firstly travel out of the racking carefully with or without the pallet. By
travelling out of the racking, take care that the forks are not touching the racking.
Push the control stick (7) forwards. The lowering speed can be adjusted by the movement of the lever.
Lower the load until the forks are clear of the pallet, then drive the truck carefully out of the load unit.
i.
Mast front shift and back shift
Push the control stick (8) forwards, the mast shifts to the front.
Push the control stick (8) backwards, the mast shifts to the back.
j.
Fork left shift and right shift
Push the control stick (14) forwards, the forks shifts to the left.
Push the control stick (14) backwards, the forks shifts to the right.
k.
Fork tilts
Push the control stick (9) forwards, the forks tilts downside.
Push the control stick (9) backwards, the forks tilts upwards.
l.
Malfunctions
If there are any malfunctions or the truck is inoperative, please stop using the truck and activate the
emergency button (1) by pushing it. If possible, park the truck on a safe area, turn the key switch (2)
counterclockwise and remove the key.
Inform immediately the manager and, or call your service. If necessary, tow the truck out of the operating
area by using dedicated towing/ lifting equipment.
When the truck has default, the wrench indicator light on the bottom of the indicator will be on. Then we
can use CURTIS hand-held unit to find out the fault reason.