22
Battery power is displayed in the right side, if fully charged, the indicator shows 100% (10 segments),
when the battery power only has 20%, the battery symbol will light on (the sixth one from left), indicating
it needs charging. When the battery power only has 10%, the prohibition symbol will light on (the fourth
one from left), and the truck can
’
t lift, but can drive slowly.
When the battery is removed, the indicator will show TRA: 5.7, then the truck can
’
t drive, but you can
move the mast. and the Max. lifting height is about 600mm.
There is key Mode on the right side of the indicator, you can switch driving mode by this key Mode.
Shown as upper left corner in Fig. 13
H
Mode
high speed mode top speed drive 10Km/h
S
Mode
normal mode
top speed drive 8.4Km/h
E
Mode
economic mode
top speed drive 6.3Km/h
When switch to the economic mode, the slow speed indicator is on (the first one from left).
c.
Charging
•
Before charging ensure that you are using an appropriate charger for charging the
installed battery!
•
Before using the charger, please fully understand the instructions of the charger
instructions.
•
Please follow these instructions!
•
The room, where you are charging must be ventilated.
Park the truck at a dedicated secured area with a dedicated power supply. Lower the forks and remove
the load.
Switch the truck off and connect the battery plug to the charging plug of the charger. The charger starts
charging the battery.
Disconnect the battery plug after the charger finished charging. Connect the plug (18) with the plug at
the truck.
8. REGULAR MAINTENANCE
•
Only qualified and trained personnel are allowed to do maintenance on this truck.
•
Before maintaining, remove the load from the forks and lower the forks to the
lowest position.
•
If you need to lift the truck, follow chapter 4b by using designated lashing or jacking
equipment. Before working, put safety devices (for instance designated lift jacks,
wedges or wooden blocks) under the truck to protect against accidental lowering,
movement or slipping.
•
Please pay attention by maintain the tiller arm. The gas pressure spring is
pre-loaded by compression, carelessness can cause injury.
•
Use approved and from your dealer released original spare parts.
•
Please consider that oil leakage of hydraulic fluid can cause failures and accidents.
•
It is allowed to adjust the pressure valve only from trained service technicians.
Check the items emphasized in maintenance checklist.
Summary of Contents for RT16P
