Noblelift RT16P, Service Maintenance Manual

Page: 13 / 50

11
Brake: To stop the truck when it is driving.
Tip over protection:
To reduce the risk of side tip over of the truck. It’s forbidden to remove the
protection.
Pedal switch: Operate the truck with left foot on the foot pedal switch, otherwise it will be failed.
Attention: Emergency button, drive key switch, brake, rollover protection, pedal switch and hydraulic
circuit explosion-proof valve are safety devices of the truck. Safety devices and labels above must be
kept in good condition, please replace in time in case of damage or absence.
d.
Identification plate (ID-plate)
Reach Truck
Special Equipment Manufacturing License No. TS2510350-2021 Tel: 4008-836115
Type xxxx Rated Capacity xxxx kg
Nominal Voltage xx V Self Weight xxxx kg
Max Battery Weight xxx kg Min Battery Weight xxx kg
Own Mass without Battery xxx kg Max Lifting Height xxxx mm
Serial Number Manufacturing Date
Device Code Manufacturer Art.No
This truck is only used in factories, tourist attractions and tourist sites.
Noblelift Intelligent equipment co. LTD
No.528 Changzhou Road, Taihu Sub-district, Changxing County, Zhejiang Province
，
China
3. WARNINGS, RESIDUAL RISK AND SAFETY INSTRUCTIONS
⚫
Do not use truck in environments with explosive gas, explosive dust or acid and alkali corrosion;
⚫
Do not use truck in the environment with poor outdoor or ground conditions;
⚫
Do not put feet or hands under or inside the lifting mechanism;
⚫
Do not stand in front or behind the truck while driving or lifting/lowering;
⚫
Do not overload, the load weight and lifting height must meet load curve requirements;
⚫
Do not put foot outside the truck when driving which may cause injuries;
⚫
Do not lift people may which may cause people falling down and severe injury suffering;
⚫
Do not push or pull goods;
⚫
Do not drive the truck on slopes;
⚫
Do not use truck with unstable, loose or unbalanced load, gravity center must be between two forks;
⚫
To prevent against unauthorized access, park the truck, turn off the power and pull out the key;
⚫
Do not make any truck modification without written consent from manufacturer;
⚫
Do not lift the cargo in the case of wind. Lifting will be unstable under the wind influence.
Watch difference in floor levels when driving. Load could fall down or the truck could get uncontrollable.
Keep watching the condition of load. Stop operating the truck if load becomes unstable.
Brake the truck and activate the emergency button by pushing when sliding load on or off the truck. If the
truck has any malfunctions, follow chapter 8.
Fig 5: Identification plate