NKT Photonics A203-000-001, Product Manual

Page: 46 / 77

CONTROL overview
46
Interlock
Indicates the status of the Interlock circuit and whether emissions can be turned
on or not. The indicator will be either:
•
ON Red – the interlock circuit is open or shorted to ground – no emission
allowed
•
ON Green – the interlock circuit is closed and reset – emission allowed
To clear the ON Red indicator, close the interlock circuit and reset it. Any shorts
to ground or circuit opens must be removed.
Status
Indicates the operational status of the laser. The indicator has the following
states:
•
ON Green – the SELECT is ready for operation.
•
ON Red – the SELECT has experienced a fault and has shutdown. An error
code is displayed underneath the Status indicator. Contact NKT Support if
the fault cannot be cleared - see “Support Contact Details” on page 53 .
System Info
The System Info section shows the following:
•
SELECT Serial number
•
SELECT Firmware version
See “View” on page 49 on toggling on and off the display of system information.
RF Power button
The RF power button toggles the supply of the External RF Driver (ERD) RF signal
power to the AOTF crystal(s). When clicked ON, the button indicator turns ON
RED and the crystal filters the beam according to the RF signal ( “Channel buttons
and text input fields” on page 50 ). When clicked OFF, no filtered output is
possible.
When this button is checked ON, the RF LED of the ERD is lit ON Red.
Emission button
The emission button enables or disables the SuperK laser emission. The button
indicator turns ON Red when laser emissions are enabled. When disabled, the
indicator is OFF Grey. This button is the same button available in the CONTROL
status panel of the SuperK laser. Refer to the SuperK laser documentation for
further information on managing emission.