83
82
Connecting using AOSS
If your access point supports AOSS, you can use this functionality for an easy
connection setup. Also refer to the instruction manual of your access point.
Note:
Using AOSS may cause your access point settings to change. If you’re connected to
a computer without using AOSS, it may no longer connect after using AOSS.
Touch an open connection, indicated by
NONE.
2
Touch the AOSS icon.
Proceed to the following access
point steps.
3
Touch OK to perform a connection test.
5
Press the AOSS Button until the lamp starts
blinking.
Note:
If connection continues to fail when performing
AOSS settings, wait approximately 3 minutes and then
try again.
4
If the connection test is successful, your settings are complete.
Immediately after completing settings for AOSS, connection may fail due to
the restarting of the access point. Wait a short while, then try performing a
connection test again.
Using AOSS
AOSS
Button
Internet
How to Connect
Touch CONNECTION SETTINGS.
1
Access point steps
Using AOSS
TWL_MAN_AUS_AppsSection.qxp 09.1.16 4:06 PM Page 82
