ENGLISH
USER MANUAL
14
1464020000(1)2009-04 A
SR 1101 P
Stopping the machine
To stop the machine release the pedal (2).
1.
To stop the machine quickly, also press the service brake pedal (3).
In case of emergency, press the emergency push-button (88) to immediately stop the machine. To deactivate the emergency
push-button (88), turn it in the direction shown by the arrow.
Lift the side brooms (10 and 11) with the lever (91).
2.
Turn off the vacuum system by bringing back the switch (85) to the centre.
3.
Lift the main broom (12) with the lever (92).
4.
To stop the machine, turn the ignition key (82) to “0”.
5.
Engage the parking brake.
6.
PARKING BRAKE
Engage the parking brake by pressing the pedal (3) and engaging the lever (4).
1.
Disengage the parking brake by pressing and releasing the pedal (3).
2.
WARNING!
Before performing any maintenance, repair, cleaning or replacement procedure engage the parking brake.
Engage the parking brake when parking the machine on a slope or incline.
MACHINE OPERATION
WARNING!
Pay careful attention when operating the machine at high speed: sudden steering could cause this three-wheel
machine to become unstable due to weight distribution.
Always reduce the speed before steering.
Avoid stopping for a long time with the machine in the same position and the brooms rotating: this could create unwanted
1.
marks on the
fl
oor.
To collect light and bulky waste materials, lift the front skirt by pressing the pedal (5); take into consideration that the machine
2.
vacuum capability is reduced when the front skirt is lifted.
CAUTION!
When operating on wet
fl
oors, it is essential to turn off the vacuum system by pressing the switch (85) to
prevent the dust
fi
lter from being damaged.
For machine proper operation, the dust
fi
lter must be as clean as possible. To clean it while sweeping, turn on the
fi
lter shaker
3.
by pressing the switch (85) forward for a few seconds.
During this operation the vacuum fan is automatically shut off.
After cleaning the
fi
lter, press the switch (85) backward to restart the vacuum system; then start sweeping again.
While working, repeat the procedure every 10 minutes on average (depending on the dustiness of the area to be cleaned).
NOTE
When the dust
fi
lter is clogged and/or the hopper is full, the machine cannot collect dust and debris anymore.
The hopper (17) should be emptied after each working cycle and whenever it is full (see the procedure in the following
4.
paragraph).
