ENGLISH
USER MANUAL
20
1464020000(1)2009-04 A
SR 1101 P
DUST FILTER CLEANING AND INTEGRITY
CHECK
NOTE
Besides the standard paper
fi
lter, polyester
fi
lters are
also available. The following procedure is applicable
to each type of
fi
lter.
Drive the machine on a level ground and engage the
1.
parking brake.
Turn the ignition key (72) to “0”.
2.
Disengage the hook (18) by pulling its lower end.
3.
Remove the hopper (17) by using the handle (19) and by
4.
disengaging it from the inner guides.
Unscrew the knobs (33) and remove the
fi
lter compartment
5.
cover (32).
Loosen the knobs (A, Fig. 9).
6.
Disconnect the
fi
lter shaker motor (C) electrical connector
7.
(B).
Remove the dust
fi
lter fastening frame (D).
8.
Remove the dust
fi
lter (E).
9.
In an outdoor area, clean the
fi
lter by shaking it on a level
10.
and clean surface, tapping the side (A, Fig. 10) opposite to
the wire gauze (B).
Complete the cleaning procedure by using compressed
air (C) at maximum 6 Bar, blowing only from the side
protected by the wire gauze (B), at a minimum distance of
30 cm.
According to the
fi
lter type, observe the following cautions:
Paper
fi
lter (standard): Do not use water or detergents
•
to clean it, otherwise it can be damaged.
Polyester
fi
lter (optional): For a better cleaning, it is
•
allowed to wash the
fi
lter with water and non-lathering
detergents. This provides better quality cleaning but
reduces the life of the
fi
lter, which will have to be
replaced more frequently. Using inadequate detergents
can damage the
fi
lter.
Check the
fi
lter body for tears. If necessary, replace the
11.
fi
lter.
Clean the rubber gasket (A, Fig. 11) of the cover (32) and
12.
check it for integrity and ef
fi
ciency; if necessary replace it.
Assemble the components in the reverse order of
13.
disassembly, and note the following:
Install the
fi
lter (E, Fig. 9) with the wire gauze (B, Fig.
•
10) facing upwards.
B
C
E
A
D
A
S311397
Figure 9
S311399
Figure 10
A
S311398
Figure 11
