Chapter 4 Assembly
100
Figure 4-20 Lamphouse attachment
Figure 4-21 Fixing the cable
Figure 4-22 Ferrite core attachment
4. Attach the lamphouse to the dia pillar
illuminator.
CAUTION: HOT
- Do not touch the lamp
and the lamphouse while the lamp is on
or for thirty minutes after it has been
turned off.
(1) Insert the lamphouse into the lamphouse
mount at the top of the dia pillar illuminator.
Align the positioning pin on the dia pillar
illuminator with the groove on the cylinder of
the lamphouse.
(2) Insert a hex screwdriver into the hole on the
top of the dia pillar illuminator. Secure the
lamphouse by tightening the lamphouse
clamp screw.
(3) Secure the lamphouse cable with the cable
clamp on the back of the dia pillar illuminator.
The cable clamp is attached to the dia pillar
illuminator with the hooks on its sides. To
remove the cable clamp, push in the hooks
from the sides.
The cable clamp can hold up to four cables.
5. Attach the provided ferrite core on the
connector end of the lamp cable.
(1) Snap open the ferrite core.
(2) Wrap the lamp cable once around the ferrite
core, so that the cable passes through the
ferrite core twice.
Adjust the position of the ferrite core so
that it is approximately 10 mm from the
lamp cable connector.
(3) Close the ferrite core.
*
For details on connecting the lamphouse, the
power supply device, and Ti-E or Ti-E/B, refer
to “13. Connecting the power supply device.”
Lamphouse
clamp screw
Cable clamp
Insert hex wrench and
tighten clamp screw.
10 mm
Ferrite core
The lamp cable is
passed twice in
the ferrite core.
Connector
Summary of Contents for Eclipse Ti-E
Page 1: ...Inverted Microscope Instructions M450 E 07 10 NF 1 ...
Page 2: ......
