NightWatcher 4 channel D1 Realtime DVR, User Manual

Page: 26 / 54

25
You can set the area as followed, Drag the mouse and draw
the area. Default: all selected blocks are detection area.
Note: Only the motion detect under hybrid mode have
this function of setting region, and also only the analog
channel can set region.
Period:
Trigger the motion detect signal in the set period
section. You can set according to week or set uniformly.
Each day is divided into four time sections. “■” means the
set valid.
Interval:
Only one alarm signal is turned on even
there are several motion detect signals in the set
interval.
Alarm output:
Start the external equipment of
corresponding linkage alarm when the motion
detect alarm is turned on.
Delay:
Delay a few moments and stop when the
alarm state is turned off. The range is 10~300
seconds.
Record channel:
Choose the recording channel
(multiple option supportive). Trigger the video
signal when the alarm is turned on.
Note:
Set in the [recording setup] and perform the
linkage recording. Start detecting video files in the corresponding time section.
Tour:
“■”means that the selective channel is single window alternate patrol preview. The interval is set
in the [Main Menu] >[System] > [Tour].
Snapshot:
Choose record channels, when alarm happens, system triggers related channels for
snapshot signal.
Note
: For Snapshot activation, please go to set period, detect and alarm enable at Main Menu->
Record->Record configure.
PTZ Activation:
Set the PTZ activation when the alarm is turned on.
Note:
PTZ activation is set in the [shortcut menu] > [PTZ control]. Set the patrol between spots, trail
patrol and so on.
Delay:
When alarm is over, recording will last some seconds (10~300sec), then stop.
Show message:
Pop the alarm information dialog box in the local host computer screen.
Send EMAIL:
“■”means sending an email to user when the alarm is turned on. (
Note:
Set in the [Net
Service] and send email.)
Alarm Setup
– Motion Detection