20
Record Setup
– Record Conf, Snapshot Conf
When you do the double backup, make sure that there are two hard disks installed. One is read-write
disk and the other is redundant disk.
Length:
Set the time length of each video file. 60 minutes is default value.
Pre-Record:
Record 1-30 seconds before the action. (time length is decided by the code stream)
Record mode:
Set video state: schedule, manual or stop.
Schedule:
Record according to the set video type (common, detection and alarm) and time
section.
Manual:
Click the button and the according channel is recording no matter the channel in any
state.
Stop:
Click the stop button and the according channel stops recording no matter the channel in
any state.
Period:
Set the time section of common recording, the recording will start only in the set range.
Record type:
Set recording type: regular, detection or alarm.
Regular:
Perform the regular recording in the set time section. The video file type is “R”.
Detect:
Trigger the “motion detect”, “camera mask” or “video loss” signal. When above alarm is
set as opening recording, the “detection recording” state is on. The video file type is “M”.
Alarm:
Trigger the external alarm signal in the set time section. When above alarm is set as
opening recording, the “detection recording” state is on. The video file type is “A”.
(Note
：
：
：
：
Refer to
Alarm Setup
to set corresponding alarm function)
◆
SnapShot Conf
Note: Snapshot function should be customized, then DVR will be with this function.
Setup snapshot parameters for different channels. At first time it is set for 24 hours snapshot
continuously, please go to Main Menu->Record->Snapshot Conf for appropriate settings.
Channel:
Select the related channel to
set, click "all" to set all channels.
Pre Snap:
Setup pre-snap picture
quantity before recording, default is 5
pieces.
Record:
Set record status, "Schedule",
"Manual" and "Stop"
Schedule:
Realize
snapshot
according to record type (regular,
detect and alarm) and period.
Manual:
No matter what the present
channel is in a state, once choose
"manual"
button,
it
will
have
snapshot at related channels.
Stop:
No matter what the present channel is in a state, once choose "stop" button, it will stop
snapshot at related channels.
Summary of Contents for 4 channel D1 Realtime DVR
Page 1: ......
Page 19: ...18 Record Advanced Alarm Info System Logout Main Menu...
