Nidec SHIMPO DT-5TFR, Instruction Manual

Page: 4 / 20

4
Refer to the following procedure to attach the unit to the attachment panel. Prior to starting attachment work,
be sure to con fi rm that the attachment panel thickness is 1.2 to 5 mm.
Remove the attachment
adapter from the unit.
䢳 䢴
䢶 䢷 䢵
Attach the provided water-proof packing to the panel surface.
While pushing the attachment
screw, open the attachment
adapter outward and remove it.
* When the water-proof feature is unnecessary, this step can be skipped.
ձ
Peel the perforated outer frame
(backing paper + Water-proof packing)
(The surface of both sides of the water-
proof packing is adhesive.)
ղ
Attach the provided water-proof packing
to the edges of the unit attachment panel
and opening, aligning with its left and right
sides, and then peel off the backing paper.
* At this time, be sure not to make the
water-proof packing displaced or wrinkled.
Also, DO NOT elongate the water-proof
packing in any directions (i.e. upper, lower,
left and right).
Ecure the unit to the panel
with the attachment screws.
The speci fi ed torque to fasten the
screws is 6.5kgf
࣭
cm or less.
Place the unit horizontally
and then insert it into the
panel's attachment opening.
Push the unit into the opening so
that the water-proof packing's ad-
hesive part is securely attached to
both unit and panel surfaces.
Attach the attachment
adapter to the unit.
Attach the attachment adapter to
the attachment hole from the side.
* Panel thickness: 1.2 to 5 mm * Rear view after the unit is attached to
the panel.
* If these screws are fastened excessively,
the attachment adapter can be deformed.
Note:Water-proof requirements
࣭
Front panel:IP66 (or similar level)
࣭
Rear terminal block:IP20 (non-water-proof)
DO NOT install the unit in the following areas:
ձ
Where water can come into direct contact with the unit always.
ղ
Where oil or chemicals can come into direct contact with the unit.
ճ
Where water can be splashed on the unit's rear or side face(s).
* The front panel is water-proofed with IP66 (or similar level). However, if water is splashed on the unit,
be sure to wipe it off the unit as soon as possible.
㻭㼠㼠㼍㼏㼔㼙㼑㼚㼠㻌㼍㼐㼍㼜㼠㼑㼞
㻭㼠㼠㼍㼏㼔㼙㼑㼚㼠㻌㼟㼏㼞㼑㼣
䐟
䐠
㻻㼡㼠㼑㼞㻌㼒㼞㼍㼙㼑
㻌㻔㻮㼍㼏㼗㼕㼚㼓㻌㼜㼍㼜㼑㼞㻌㻗㻌㼃㼍㼠㼑㼞㻙㼜㼞㼛㼛㼒㻌㼜㼍㼏㼗㼕㼚㼓㻕
㻮㼍㼏㼗㼕㼚㼓㻌㼜㼍㼜㼑㼞㻌
㻔㼠㼔㼑㻌㼟㼕㼐㼑㻌㼣㼕㼠㼔㼛㼡㼠㻌㼜㼑㼞㼒㼛㼞㼍㼠㼑㼐㻌㼘㼕㼚㼑㼟㻕
㻮㼍㼏㼗㼕㼚㼓㻌㼜㼍㼜㼑㼞
㻌
㻔㼠㼔㼑㻌 㼟㼕㼐㼑㻌 㼣㼕㼠㼔㻌 㼜㼑㼞㼒㼛㻙
㼞㼍㼠㼑㼐㻌㼘㼕㼚㼑㼟㻕
㼃㼍㼠㼑㼞㻙㼜㼞㼛㼛㼒㻌㼜㼍㼏㼗㼕㼚㼓㻌㼍㼐㼔㼑㼟㼕㼢㼑㻌㼜㼍㼞㼠
㼁㼚㼕㼠㻌㼍㼠㼠㼍㼏㼔㼙㼑㼚㼠㻌
㼛㼜㼑㼚㼕㼚㼓
㻮㼍㼏㼗㼕㼚㼓㻌㼜㼍㼜㼑㼞
㻼㼍㼚㼑㼘
㼃㼍㼠㼑㼞㻙㼜㼞㼛㼛㼒㻌㼜㼍㼏㼗㼕㼚㼓
㻭㼠㼠㼍㼏㼔㼙㼑㼚㼠㻌㼍㼐㼍㼜㼠㼑㼞
㻭㼐㼍㼜㼠㼑㼞㻌㼍㼠㼠㼍㼏㼔㼙㼑㼚㼠㻌㼔㼛㼘㼑㼟
㻼㼍㼚㼑㼘
㻼㼍㼚㼑㼘
㻭㼠㼠㼍㼏㼔㼙㼑㼚㼠㻌㼟㼏㼞㼑㼣
Unit Attachment to Attachment Panel