Nice E FIT MP 1517, Instructions And Warnings For Installation And Use

Page: 9 / 56

English –
8
4.11 - Total or partial deletion of memory
This procedure allows you to choose under point 5 the data that you want to delete.
Procedure performed with a transmitter memorized in “Mode 1”
1 2

3
=
5
sec
2
= 5 sec
3
Keep the button
pressed count 2 movements release the button Keep the button
pressed count 3 movements release the button
3
 4
= 5 sec
3
Keep the button
pressed count 3 movements release the button
4

5
= 5 sec
3
Keep the button
pressed count 3 movements release the button
Note – When performing the procedure, you can cancel it at any time by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
• To cancel the entire memory
5
the end
= 5 sec
5
Keep both buttons
pressed at the
same time count 5 movements release the buttons
• To delete only the memorized transmitters
5
the end
= 5 sec
5
Keep the button
pressed count 5 movements release the button
• To delete only the limit switch heights and intermediate heights
5
the end
5
Keep the button
pressed count 5 movements
ATTENTION!
This deletion must be performed only when
you want to adjust the limit switch heights
again, using a different procedure than the
one used previously. Whereas if you want to
adjust heights with the same procedure, it is
not necessary to delete them from memory.
English –
8
EN