Installing the boiler
Burner
APH
The burner is installed in the outlet for the burner on PEL-
LUX 100s burner hatch. The burner is then secured into
position using the knobs supplied for the burner.
Pellet hopper and pellet screw
PELLUX 100 fuel is fed from a pellet hopper of an external
pellet screw. The pellet screw should be inclined at a rising
angle of 35-45° for best function and most even pellet
feed. The pellet screw that is used should feed approx.
10 kg/h at continuous operation. The hose must be a little
bent and the hose connections slightly offset from each
other.
The pellet screw and pellet hopper are accessories, recom-
mended pellet hopper and pellet screw are:
႑
Nibe pellet hopper ZP 300
႑
pellet screw from the Nibe PP series.
which are specially adapted to work together with PELLUX
100.
The pellet store should be positioned as close to the boiler
as possible or on the left-hand side.
NOTE
Use only one of the fireproof hoses supplied with the
feed screw to connect the pellet screw to the burner!
NOTE
Ensure that the boiler door cannot be opened when
the fireproof hose is connected to the boiler!
LE
K
1. Position the pellet hopper in a suitable location and
open the appropriate hole in the front.
2. Install the pellet screw in the opened hole and to the
feed pipe in the bottom of the pellet hopper.
3. Install the hose and hose clips on the pellet screw
outlet pipe and the burner feed pipe.
4. Make any adjustments of the hose lengths. The hose
must have slight bends to prevent sawdust collecting
in it. The pellet screw outlet section must be slightly
offset in relation to the burner's inlet section.
5. Connect the pellet screw connector to the burner and
connect it to the control computer.
6. Detach the hose from the supply pipe and run the
pellet auger via the control computer to supply pellets.
A
Open the simplified menu using the up or down
arrow.
B
Scroll to
Fuel supply
with Up arrow.
C
Open using Enter.
D
Set to Yes
7. When pellets drop down through the hose, preferably
into a bucket, run for an extra minute to ensure an
even supply.
8. Stop the supply by setting
Fuel supply
to No. (see point
6).
9. Reinstall the hose on the feed pipe.
PELLUX 100
18
For the Installer
Installing the boiler
