Nibe BA-SVM 10-200 Series, Installation And User Manual

Page: 68 / 88

68 NIBE BA-SVM 10-200
12 Accessories
Room sensor RTS 40
Air/water heat pump
Auxiliary contactor HR 10
More accessories are available on the website
https://www.nibe.eu
MODBUS 40 Communication module
Room unit RMU 40
Condensation water drainage pipe
Extra shount group ECS 40/ECS 41
Accessory card AXC 30
ECS 40 (max. 80m
2
) ECS 41 (max. 250m
2
)
This accessory is used to obtain a more even indoor
temperature.
Part no. 067 065
MODBUS 40 allows for control and monitoring of
the controller using the BMS (building management
system). Communication is then handled by MOD-
BUS-RTU.
Part no. 067 144
RMU 40 means that control and monitoring of the
heat pump can be carried out in a different part of
your home to where it is located.
Part no. 067 064
Part no. 067 287 Part no. 067 288
This accessory is used when the controller is installed
in houses with two or more different climate systems
that require different supply temperatures.
Length - 1 metre
Part no. 067 614
Length - 3 metres
Part no. 067 614
Length - 6 metres
Part no. 067 614
Auxiliary relay HR10 is used to control external 1 to 3
phase loads such as oil burners, immersion heaters
and pumps.
Part no. 067 309
An accessory board is required in case of active cool-
ing (4-pipe system), an additional climate system, or
if more than four feed pumps are to be connected to
the controller. It can also be used in case of additional
heat controlled by a shunt valve (e.g. wood/oil/gas/
pellet boiler). An accessory board is required if, for
example, a hot water circulation pump is to be con-
nected to the controller where the AA3-X7 output is
activated for the QN12 valve.
Part no. 067 304
AMS 10-8 AMS 10-6
KVR10-10
KVR10-30
KVR10-60
AMS 10-12
Part no. 064 033 Part no. 064 205 Part no. 064 110
Section 12 | Accessories
Available accessories