Nibe AMB 30, Installer Manual

Page: 30 / 52

Service
MR
OK
Press in
for 6 seconds
MR
OK
Service
Systemtype
Settings
Testmanually
OK
Ground
5 °C/3 °C
Operationmode
NOTE
Service mode is exclusively for the installer or
the service technician. The user should not
make changes to these settings.
During installation or service you will need to enter
service mode to make/check installation settings and
test any outputs on the relay card -AA6. This is done
by holding in the
[OK] button for 6 seconds.
Here the buttons [-] and [+] are used to scroll through
the options. [OK] is used to select the option. Return
to previous image by scrolling to the top and pressing
[-] .
Description Service
In this menu you can choose what
type of system AMB 30 has been
docked to. System type
Installation specific settings can be
made in this menu. Settings
In this menu the outputs on relay
card -AA6 can be tested manually,
which can, for example, facilitate
troubleshooting. Test manually
AMB 30 Chapter 8 | Control - Menus 28
8 Control - Menus