5 - MANAGEMENT WITH REMOTE CONTROL
This procedure lets you programme/delete compatible multifunctional or generic (Wireless bus) transmitters.
Multifunctional transmitters:
With multifunctional transmitters the transmitter control modes depend on the model used.
Refer to the transmitter manual, to the paragraph entitled “commands sent by the transmitter”, bearing in mind that:
this is a dimmer and motor device.
Generic (wireless bus) transmitters:
With generic transmitters, the functions associated with the key are those of motor step / step control and On / Off-
Dimmer of the light.
5.1 - RADIO PROGRAMMING
This procedure lets you programme compatible multifunctional or generic transmitters.
Depending on the number of lines of LED strip lights set with the procedure in paragraph 3.4, the remote control can be
programmed for the active outputs.
PROCEDURE
STEP 2
Within 10 seconds make a transmission with the transmitter
to be saved.
See transmitter manual, the paragraph entitled “transmitter
programming” for specify information.
The led makes 3 Flashes and turns off.
ACTION:
Make a transmission with the transmitter
LED:
Flashes 3 times
STEP 1b
Press key 1 as many times as
the output number on which
you want to program the
transmitter
STEP
1d
Press key 1 as many times as
the output number on which
you want to program the
transmitter
STEP 1c
Press key 1 as many times as
the output number on which
you want to program the
transmitter
MOTOR AND
1 LINE OF LEDS
(See paragraph 3.4)
MOTOR AND
3 LINES OF LEDS
(See paragraph 3.4)
MOTOR AND
2 LINES OF LEDS
(See paragraph 3.4)
No. of
presses
LED
colour
Output paired
with TX
1
Red
MOTOR
2
Green OUT1-2-3
3
Off
/
No. of
presses
LED
colour
Output
paired
with TX
1
Red
MOTOR
2
Green OUT1
3
Blue
OUT2
4
Yellow OUT3
5
Off
/
No. of
presses
LED
colour
Output
paired
with TX
1
Red
MOTOR
2
Green OUT1
3
Blue
OUT2
4
Off
/
X1 OUT1 (RED)
X2 OUT2 (GREEN)
X3 LED OFF
X1 OUT1 (RED)
X2 OUT2 (GREEN)
X3 OUT3 (BLUE)
X4 LED OFF
X1 OUT1 (RED)
X2 OUT2 (GREEN)
X3 OUT3 (BLUE)
X4 OUT4 (YELLOW)
X5 LED OFF
10
