2 - MOTOR AND SENSORS ELECTRICAL CONNECTIONS
WARNINGS
•
Installation must be carried out only by qualified technicians in compliance with the electrical and safety standards in
force.
•
All connections must be made with the power turned off.
•
Use suitable cables.
•
Do not cut through the aerial
•
A suitably sized disconnection device must be set up on the electric power line that supplies
the product
•
Disposal of waste materials must fully respect local standards.
•
Do not exceed the load limits shown and use protected power supply units of the correct size for the load.
* NOTE:
•
The operation of the inputs can be set, see paragraph 6.4
•
See paragraph 3 for connecting the LEDs and setting the number of outputs
TERMINAL
NUMBER
DESCRIPTION
1
230V phase power supply
2
230V neutral power supply
3
230V phase (for accessories power supply)
4
230V neutral (for accessories power supply)
5
Motor ouput, close (L)
6
Motor output, common (N)
7
Motor ouput, open (L)
8
230V phase (for accessories power supply)
9
230V neutral (for accessories power supply)
10
+ output led
11
+ output led
12*
OUT led 1 (-)
13*
OUT led 2 (-)
14*
OUT led 3 (-)
15
Not used
16*
Input 2: default= rain sensor
17
433,92MHz antenna signal
18
Not used
19
Not used
20
Led power (12 or 24Vdc)
21
Led power supply -
22
Input common
23*
Input 1: default= vento
ANT
L
(in)
(out)
(out)
L
N
N
L N
M
Input 2, rain sensor*
Input 1, wind sensor*
Input common
17 18 19 20 21 22
10 11 12 13 14 15 16
23
1
2
3
4
5
6
7
8
9
4
