Nexo PS Series, User Manual

Page: 37 / 82

PS S
ERIES HARDWARE SETUP PROCEDURE
Page 37/82
Procedure
Vertical

12mm diameter screws (not provided) are required to secure the wall suspension plate on the
wal;

Remove the 2 rear TORX screws holding connector plates on both sides of PS10R2 or PS15R2;

Fill each screw hole with Locktite 243 or equivalent;

Connect the suspension plate to the connector plate by using the srews provided with the VNI-
WS kit;

Position the srews in the oblong hole so that required vertical angle is obtained;

Secure the screws;

Suspend and secure the cabinet to the wall suspension;

Adjust horizontal angle.
WALL SUSPENSION PROCEDURE FOR VERTICAL INSTALLATION