Nexo PS Series, User Manual

Page: 35 / 82

PS S
ERIES HARDWARE SETUP PROCEDURE
Page 35/82
7.3.3 PS10R2 and PS15R2 mounted on a ceiling (vertical or horizontal)
Required items
Ceiling Cable suspension:

1 or 2 x VNI-LBRK (holes for cable suspension are 10mm diameter);

2 or 4 slings and corresponding shackles (not provided)
Ceiling Rigid suspension

1 VNI-ABRK
IMPORTANT
Ensure that the ceiling is strong enough to hold 4 times PS cabinet weight and that the
cable suspension system required to install the cabinet under the ceiling is properly
dimensioned.
Procedure
Vertical (PS10R2 and PS15R2)

Remove the four TORX screws holding
connector plate on upper side of PS;

Remove the connector plate from PS
cabinet;

Fill each screw hole with Locktite 243 or
equivalent;

Position external plate from VNI--LBRK
kit or VNI-ABRK kit and secure it using
the 2 of the 4 shoulder screws supplied
with this kit;

Position bracket from VNI-LBRK kit, or
VNI-ABRK and secure it to the cabinet
using the 2 remaining shoulder screws
supplied with this kit.

Slings and shackles (not provided) are
required
to secure the cable
suspension under the ceiling;
CABLE SUSPENSION MOUNTING PROCEDURE 2