16
NewTom GO 2D/3D
EN
2D/3D OPT E.L. CALIBRATION MANUAL
To correct the positioning of the vertical line, adjust
the highlighted grub screws and screws (placed in the
lower part of the kinematic mechanism – remove the
accessory drawer to see them).
If the image obtained is similar to the following one,
adjust the left-hand screw and grub screw; slightly lo-
osen screw B and tighten grub screw A (some strength
is necessary) to modify the position of the chinrest.
Vice versa, if the image is similar to the following one,
adjust the right-hand screw and grub screw.
At the end of each adjustment, press “Retry” to acqui-
re a new image and assess it; if necessary, repeat the
operation until an image similar to the following one
is obtained.
To change the image focus position, modify the value
contained in the “offset Y” field, confirm by means of
the arrow and press “Retry” in the dialog box in the
foreground.
At the end of the procedure, when the focus is centred
and the line is perfectly vertical, press “OK” to confirm
and save the data.
