NewMar King Aire 2015, Manual

Page: 59 / 238

1.
Remove the Phillips head screw that is screwed into the well nut that is assisting in holding on the
end cap.
2.
Grasp rubber well nut that the Phillips head screw is screwed into. Pull the well nut out of the hole.
3.
Take the provided 7mm Allen wrench and put it into a 3/8” battery operated drill.
4.
Place the Allen wrench down in the hole where the well nut was removed. Insert the Allen wrench
into the Allen Head screw that is down inside the case (note: you will have to do this by feel as you
cannot see the Allen Head screw once the wrench is inserted into the hole).
5.
To close the awning, operate the drill in the “forward” direction. To open the awning, operate it in the
reverse direction.
IMPORTANT
The “wind sensor” for the power awnings is designed to retract the awnings should sustained winds over 22
mph be detected. Note that is it not designed to retract the awnings for wind gusts. It is recommended that
you monitor your awnings in gusty wind or heavy rain situations. You should also retract them if you are going
to be away from your unit for an extended period when there is the possibility for wind or rain storms to
minimize the possibility of damage.
“Oasis” Entry Door Awning
The “Oasis” entry door awning is a power operated awning. To extend the awning, press the “Extend”
button on the switch plate. To retract it, press the “Retract” button. Please note that both buttons must be
held down as the awning travels in or out. It will not extend or retract automatically.
Window Awnings
Also standard on your unit are the matching window awnings. They are operated as all the power awnings
on your unit are. Use the appropriate switches to extend or retract the awnings as desired, and always
check for clearance on the exterior of the unit to be certain nothing will interfere with their deployment.
2015 Newmar King Aire Diesel Bus 57