ChipSHOUTER Users Manual
: Ballistic Gel EMFI Target
(CW522)
34
3.
Connect the ChipSHOUTER to your computer by first us-
ing an RJ12 cable to connect the ChipSHOUTER to the
USB interface board, and then connecting the interface
board to your computer using a micro-USB cable.
4.
If drivers for the interface are not installed, in-
stall the universal FTDI VCP driver from the FTDI
website. The interface should connect as a virtual com
port, which can be confirmed using your computers de-
vice manager.
5.
Start a terminal session using your favorite terminal
program. PuTTY works well for this. The serial config-
uration of the ChipSHOUTER is 115200 baud 8N1
6.
Connect the 19V power adapter to the ChipSHOUTER. If
your terminal was configured correctly a welcome mes-
sage should be displayed as the device boots.
7.
Test connectivity with the shouter by sending a ques-
tion mark (?) to the device. This should return the
serial command list.
8.
In a separate command line or python interpreter, run
ballisticgel.py
to connect to the ballistic gel tar-
get.
9.
Arm the ChipSHOUTER by sending the command
arm
over
the serial link. You should hear the arm chime.
10.
Hold the injection tip over the center of the SRAM
chip on the ballistic gel target. Press the pulse but-
ton on the ChipSHOUTER or send the command
pulse
over
the serial link.
11.
Disarm the ChipSHOUTER by pressing the arm button or
by sending the
disarm
command over the serial link.
