New Holland WORKMASTER 35, Operator'S Manual

Page: 80 / 180

4 - OPERATING INSTRUCTIONS
Starting the engine
Gear model
WARNING
Run-over hazard!
Always sit in the operator's seat with the park-
ing brake engaged when attempting to start
the engine. Never attempt to start the engine
while standing beside the machine.
Failure to comply could result in death or se-
rious injury.
W0967A
The key switch (1) allows activation of the starter motor
and fuel delivery only when:
· Shuttle lever (2) is in the neutral position.
· PTO switch (3) is in the "OFF" position.
· Mid PTO lever (4) is in the "OFF" position (if equipped)
· Clutch Pedal (5) is depressed.
NOTE: Although the tractor can be started with the op-
erator out of the seat, this practice is not recommended.
However, an alarm will sound if the park brake is not en-
gaged, indicating that the operator needs to engage the
park brake.
1. Push the hand throttle lever (6) forward to about the
middle position.
2. Turn the key switch to the middle "ON" position and
check if the engine oil pressure, battery charge and
cold start indicator lights are illuminated. .
3. Wait until the cold start indicator light goes off (approx-
imately ten seconds).
4. Fully and turn the key to the extreme right to the
"START" position. As soon as the engine starts,
release the key to the middle "ON" position.
NOTICE: Do not engage the starting motor continu-
ously for more than 10 seconds. Doing so may cause
starting motor failure.
5. Check if the engine oil pressure and battery charge
indicator lights are illuminated, the lights should be off.
If any of these indicator lights are illuminated, shut off
the engine immediately and check engine for possible
problem.
NHIL12CT00692AA
1
93100852
2
4-12