New Holland WORKMASTER 35, Operator'S Manual

Page: 129 / 180

7 - MAINTENANCE
4. The forward and reverse pedals should be at the same
height. Adjust pedal height by loosening bolt (1) and
rotating shaft (2) as needed. After height adjustment
is obtained, hold shaft (2) in place when tightening bolt
(1) .
5. After pedal height adjustment, is completed, check that
HST neutral switch (3) is depressed when the pedals
are in the "NEUTRAL" position. If switch is not de-
pressed, loosen bolts
(4) and adjust position of switch
so that switch is depressed. Tighten bolts after adjust-
ment is completed.
6. Start the tractor, place the range gear in "LOW" range
and engine speed at high idle.
7. Depress both forward and reverse pedals separately.
Release pedals and check if rear wheels rotate when
pedals return to the "NEUTRAL" position.
8. If rear wheels rotate when pedals are at the "NEU-
TRAL" position, adjust HST linkage by loosening jam
nuts
(5) and rotating rod (6) until wheels do not rotate.
Tighten jam nuts after adjustment is completed.
9. Remove tractor from safety stands, when adjustment
is completed.
7-21