New Holland Boomer 41, Operator'S Manual

Page: 139 / 216

7 - MAINTENANCE
7 - MAINTENANCE ###_7_###
GENERAL INFORMATION
General information
Adequate lubrication and maintenance on a regular
schedule is vital to maintaining your equipment.
To
ensure long service and efficient operation, follow the
lubrication and maintenance schedules outlined in this
manual. The use of proper fuels, oils, grease and filters,
as well as keeping the systems clean, will also extend
machine and component life.
NOTICE: While any company can perform necessary
maintenance or repairs on your equipment, NEW HOL-
LAND strongly recommends that you use only authorized
NEW HOLLAND dealers and products that meet the
given specifications. Improperly or incorrectly performed
maintenance and repair voids the equipment warranty
and may affect service intervals.
NOTICE: Always use genuine NEW HOLLAND replace-
ment parts, oils and filters to ensure proper operation, fil-
tration of engine and hydraulic systems. See your NEW
HOLLAND dealer for additional oil quantities.
Regular lubrication is the best insurance against delays
and repairs. Proper lubrication will extend machine life.
Refer to the following charts for lubricants and service
intervals.
NOTICE: Failure to complete the required maintenance
at the recommended intervals can cause unnecessary
downtime.
The intervals listed in the Lubrication Chart are guidelines
to be used when operating in normal conditions. Adjust
the intervals for operating in adverse environmental and
working conditions. The intervals should be shortened for
sandy, dusty and extremely hot operating conditions.
WARNING
Avoid injury!
1. Disengage all drives.
2. Engage parking brake.
3. Lower all attachments to the ground, or
raise and engage all safety locks.
4. Shut off engine.
5. Remove key from key switch.
6. Wait for all machine movement to stop.
Failure to comply could result in death or se-
rious injury.
W1197A
WARNING
Entanglement hazard!
Disengage the Power Take-Off (PTO), turn off
the engine, and remove the key. Wait for all
movement to stop before leaving the opera-
tor's position. Never adjust, lubricate, clean,
or unplug machine with the engine running.
Failure to comply could result in death or se-
rious injury.
W0227A
WARNING
Illustrations in this manual may show protec-
tive shielding open or removed to better illus-
trate a particular feature or adjustment.
Replace all shields before operating the ma-
chine.
Failure to comply could result in death or se-
rious injury.
W0012A
Always clean the area around dipsticks, fill caps, and
check plugs when checking fluid levels. Failure to clean
these areas may allow contamination to enter the system. Drain, flush and refill the system any time you suspect it
is contaminated.
7-1