M-Series IP Interface and PC Operations
60
432-0003-00-10 Rev 150 — M-Series Operator’s Manual
Changing the IP Address of the JCU
The JCU communicates through the Ethernet IP protocol just like the M-Series
camera does. Each JCU is configured by default to obtain an IP address
dynamically from the system.
On the JCU, the IP address is displayed by pressing the COLOR button and puck
at the same time. The IP is displayed for 3 seconds and then the display returns
to the camera name or other the state it was in before the IP request was made.
On networks with specific requirements, you may need to assign the JCU a static
IP address.You do this using steps similar to the way you changed the camera IP
address:
1.
Determine the JCU IP address by pressing the COLOR button and puck at the
same time. The IP address displays on the JCU screen.
2.
Type the JCU IP address into the address bar of the browser.
The JCU control page displays, with a picture of the JCU.
3.
For Network Addressing, select Static.
4.
Enter the new value you want to use in the IP field. The Network Mask should
fill in automatically (255.255.255.0).
5.
Click Save to save your changes and exit the control page.
When software updates become available, you can use the Firmware Update
field to load the update to the camera. Contact the FLIR dealer where you
purchased the camera for additional information, or contact FLIR directly.
www.netzerotools.com
www.netzerotools.com
