M-Series System Startup
24
432-0003-00-10 Rev 150 — M-Series Operator’s Manual
When the JCU receives power, an amber light on the Power/DIM button will
come on. When the Power/DIM button is pressed,
the JCU will search for
M-Series cameras on the network.
Troubleshooting Tip:
If the JCU does not have power, it may be connected to a
Power over Ethernet (PoE) switch that has not been powered on, or it may be
connected to a network switch that does not provide PoE power.
During bootup, a series of screens displays as various components are activated.
How the screen looks will vary depending on the particular configuration settings
of your installation. In general, the following sequence occurs:
1.
Two FLIR splash screens display.
Initially the screen at the left appears. Then another splash screen with two
important notices appears.
2.
The screen then clears and a message displays:
Loading, please wait
3.
The screen clears and displays live video using default colors and icons. A
dual payload model initially displays the IR video on both channels. Then the
IR/VIS video channel switches to the visible camera if the visible camera was
active when the camera was last powered down or placed in standby mode.
4.
If a JCU or PC is not connected to the camera, it will immediately go into
standby mode and the camera assembly will move to the stowed position.
Pressing and holding the JCU Power/DIM button or clicking and holding the
Active link on the PC Web control page will activate the camera.
Starting,
then
Searching..
displays on the JCU LCD screen. When the
last-used camera is found, the message changes to
Connecting...
, which
continues to flash until the connection process completes.
www.netzerotools.com
www.netzerotools.com