NX1348E Icon Keypad
Page 19
ADDING AND CHANGING USER CODES
Your system must be Disarmed to change user codes.
Step 1
Press [
]-[5]
Step 2
The Enter Code icon will display. Enter a [“Master Arm/Disarm” Code].
N
For partitioned systems, someone changing the code of another person
must have access to all or more partitions than the user being changed.
Step 3
The Ready icon will flash.
Step 4
Enter the 2-digit “user number”. (Always enter 2 digits such as [0]-[3] for
user 3.)
Step 5
The instant icon will flash and zone icons will illuminate specifying the first
digit of the “user code”.
When all icons are all illuminated = code is blank; when all icons are off = “0”.
Use the [
•
] and [
–
] keys to view the next digit or enter new 4- or 6-digit “user code”.
While using the [
•
] and [
–
] keys, you can change any digit by entering a new digit.
This will advance you to the next digit.
To delete a user code, enter [
]-[
]-[
]-[
] for a 4-digit
code, or [
]-[
]-[
]-[
]-[
]-[
] for a 6-digit code.
Step 6
The ready icon will flash indicating you are back at Step 2 above. If the
code is rejected, the sounder will beep 3 times.
Step 7
If another “user code” needs to be programmed, return to Step 4.
Step 8
Press the [#] key while the ready icon is flashing to exit the User Code
Programming Mode.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes
before assigning authority levels.
Step 1
Press [
]-[6]-[“Master Arm/Disarm Code”].
N
Someone changing the authority of another person can only add or
remove partition authorization for partitions to which they have access.
Step 2
The ready icon will flash.
