16 | Netstor
CLI Manager
• Set Password
Change the enclosure LCM/UART CLI password. The sub-item is "Set New PWD".
• Save Config
Save all the updated option value into non-volatile memory area.
• System Reset
Reboot the system.
4.
CLI Manager
This Command Line Interface (CLI) is provided for you to manage the 16 SAS expander
system functions. The CLI is useful in environments where a graphical user interface (GUI) is
not available.
• Locations of RS-232C Port
6Gb/s SAS JBOD enclosure uses the RJ11 port as the serial port interface. Please use the
cable included on the shipping box to configure the expander controller.
• Establishing the Connection for the RS-232 Port
The CLI function can be done by using an ANSI/VT-100 compatible terminal emulation
program. You must complete the appropriate installation procedure before proceeding with
the CLI function. Whichever terminal emulation program is used must support the 1K
XMODEM file transfer protocol.
The serial port on 6Gb/s SAS JBOD enclosure’s bracket can be used in VT100 mode. The
provided interface cable converts the RS232 signal of the RJ11 connector on the SAS
expander controller into a 9-pin D-Sub male connector. The firmware-based terminal SAS
expander management interface can access the expander through this RS-232 port. You
can attach a VT-100 compatible terminal or a PC running a VT-100 terminal emulation
program to the serial port for accessing the text-based setup menu.
