Netstor | 11
LCD Configuration Manager
Note:
1.
Please refer to chapter 4.3 CLI features of GROUP command which is used to associate
the external port and the devices/phys slot.
2.
The first thing is to turn on 6Gb/s SAS JBOD enclosure to make sure the SAS RAID
controller or SAS host adapter recognizes the drives in the enclosure.
10.
As 6Gb/s SAS JBOD enclosure provides redundant power supply unit, connect one end
of the two power cords to the two receptacles on rear of 6Gb/s SAS JBOD enclosure,
and then connect the other end of the two power cords to the outlets.
11.
After the two power cords are connected, you can switch on 6Gb/s SAS JBOD enclosure
and the computer.
3.
LCD Configuration Manager
The 6Gb/s SAS JBOD enclosure LCD configuration utility is a character-based utility that you
can run after powering the unit. Use LCD configuration utility to see and configure:
• Alarm Device,
• Voltage,
• Set Link,
• Set Alarm,
• Set Password,
• Save Config, and
• System Reset
The LCD display front panel function keys are the primary user interface for 6Gb/s SAS JBOD
enclosure. Except for the "Firmware update", all configurations can also be performed
through this interface.
