Netopia 430 S/T, Reference Manual

Page: 26 / 276

Configuring ISDN Connections 2-11
referred to as IP Proxy).
■
Select Filter Set and then select an appropriate filter set from
the list. If you do not want to block any TCP/IP traffic, then
leave this entr y blank. To define an additional filter set,see the
Filter Sets (Firewalls) section of this chapter.
Corporate Models ■ Select Receive RIP and toggle it to Yes (on) if you want the
Netopia to receive RIP information sent by remote routers that
are connected to your local area network (LAN).
Corporate Models ■
Hit Escape when you are finished configuring IP Profile
Parameters to go back to the Add Connection Profile screen.
The next section desribes how to configure the IPX parameters.
If you do not wish to enable IPX , skip to
“Setting up Number to
Dial,” beginning on page 2-14 .
Corporate Models ■
Select Transmit RIP and toggle to Yes, if you want the Netopia
ISDN Router to send RIP information to remote routers that are
connected to your local area network (LAN)
IPX configuration
parameters
■
From the Add Connection Profile screen select IPX Enabled and
toggle it to Yes or No depending on whether you will be using
IPX over your ISDN connection. The IPX protocol is required to
use with other remote networks using IPX for an Intranet
connection. For more information on IPX, refer to Chapter 5,
“IPX Setup” of this Reference Guide.