NETGEAR WM2500RP, User Manual, Page: 8 / 62

Table 1. Front panel LED and button descriptions
LED Description
WPS button
and LED WPS button . Pressing this button initiates a WPS wireless connection procedure.
WPS LED
• Solid green . Wireless security is enabled.
• Blinking green . The WiFi bridge/extender is attempting to use WPS to add a wireless
device or computer to the wireless network.
• Blinking green rapidly for about five seconds . WPS has failed to add a wireless device
or computer.
• Blinking green rapidly and continuously . The WiFi bridge/extender is stuck in the
temporary AP setup locked state. For more information, see WPS Button Blinks Amber on
page 53.
• Off . No WPS connection exists.
WiFi On/Off
button Pressing this button turns the wireless radios in the WiFi bridge/extender on or off.
5 GHz WiFi
5
GHz
• Solid blue . The 5 GHz wireless radio is operating.
• Off . The 5 GHz wireless radio is off.
2.4 GHz WiFi
• Solid green . The 2.4 GHz wireless radio is operating.
• Off . The 2.4 GHz wireless radio is off.
LAN
• Solid green . The LAN port has detected a 100 Mbps link with an attached device.
• Solid amber . The LAN port has detected a 10 Mbps link with an attached device.
• Off . The LAN port has not detected a link with an attached device.
Online • Solid amber . The IP address was not acquired.
• Solid green . The WiFi bridge/extender received an IP address and is ready to transmit
data.
• Off . No Ethernet cable is connected between the WiFi bridge/extender and the other MoCA
device.
Power • Solid amber . The WiFi bridge/extender is starting up after being powered on.
• Solid green . The power is on, and the WiFi bridge/extender is ready.
• Blinking amber . A firmware update is in progress.
• Blinking green . The firmware is corrupt.
• Off . Power is not supplied to the WiFi bridge/extender.
Hardware Setup
8
MoCA 2.0 N600 WiFi Bridge/Extender WM2500RP