Netberg Demos R420 M2, User Manual

Page: 60 / 213

Installing Hardware
49
3. Press down the HDD to locate it properly in the HDD carrier.
Figure 3.42. Installing the Rear HDD
4. Push the release button.
5. Close the lever.
6. Push the HDD assembly into the HDD cage.
Figure 3.43. Installing the Rear HDD Assembly
3.12.3. To remove the rear HDD backplane
Before you remove or install the rear HDD backplane, please follow the steps below:
1. Make sure the server is not turned on or connected to AC power.
2. Remove the node. To remove the node, see Section 3.5.1, “Removing a Mainboard Module”
3. Remove the rear HDD. To remove the rear HDD, see Section 3.12.1, “To remove the rear HDD”
4. Disconnect all necessary cables.
Steps:
1. Loosen the screws that secure the rear HDD backplane bracket.
2. Remove the rear HDD backplane bracket.