Step
Perform on each controller module
Cable the e0M ports to the management network switches with the
RJ45 cables.
DO NOT plug in the power cords at this point.
Cabling controllers to drive shelves
Option 2: Cabling a switched cluster
The optional data ports, optional NIC cards, and management ports on the controller
modules are connected to switches. The cluster interconnect/HA ports are cabled on to
the cluster/HA switch.
You must have contacted your network administrator for information about connecting the system to the
switches.
Be sure to check the illustration arrow for the proper cable connector pull-tab orientation.
As you insert the connector, you should feel it click into place; if you do not feel it click, remove
it, turn it around and try again.
1. You can used the graphic or the step-by step instructions to complete the cabling between the controllers
and to the switches:
[drw a320 switched network cabling composite animated gif] |
7