User Guide
T1/E1 configuration guide
44
12.4.1. Configuration Example 1
Below is an example of T1 CAS setting.
MAX:/CONFIG/COMMON>
change pcm ulaw
Configuration is not saved. You must save the changed configurations
Command successfully end.
You Must RESET to apply modified value(s) to system.
MAX:/CONFIG/COMMON>
change clkp dvu
Configuration is not saved. You must save the changed configurations
Command successfully end.
MAX:/CONFIG/COMMON>
change clks dvu
Configuration is not saved. You must save the changed configurations
Command successfully end.
MAX:/CONFIG/COMMON>
MAX:/CONFIG/COMMON>
show
==========================================================================
MAX System Configurations
==========================================================================
pcm_coding_law (pcm) : U-LAW
nv-memory save mode (save) : MANUAL
yes/no prompt mode (prompt) : ENABLE(ON)
watchdog timer (wdt) : ENABLE(ON)
primary clock source (clkp) : LOCAL TRUNK(DVU)
secondary clock source (clks) : LOCAL TRUNK(DVU)
==========================================================================
MAX:/CONFIG/DTRUNK>
change cfg type t1
Configuration is not saved. You must save the changed configurations
Command successfully end.
You Must RESET to apply modified value(s) to system.
MAX:/CONFIG/DTRUNK>
change cfg sig dtmf
Configuration is not saved. You must save the changed configurations
Command successfully end.
PCM coding setting :
µ
-law
Clock source setting
: clock slave
