User Guide
T1/E1 configuration guide
38
I/C A-Group signal (acomp)
This parameter is used to set group-changing mode after receiving address
information in case of receiving a call in R2 MFC signaling.
For further details, refer to ITU-T Q.441 recommendation.
MAX:/CONFIG/R2>change acomp <value>
The option value can be selected as ‘
on
’ or ‘
off
’.
I/C Calling Party Addr Request (sareq)
This parameter is used to request source address information in case of
receiving a call in R2 MFC signaling.
MAX:/CONFIG/R2>change sareq <value>
The option value can be selected as ‘
on
’ or ‘
off
’.
max number of digits to receive(mrxd)
This parameter is used to set the maximum length of the digits of an incoming
call in case of receiving a call in R2 MF signaling.
MAX:/CONFIG/R2>change mrxd <value>
The option value can be selected from 0 to 20 (0:unlimitted).
R2-MFC Tone Output Gain (gain)
This parameter is used to set output gain of R2 MFC tone.
MAX:/CONFIG/R2>change gain <value>
The option value can be selected from -31 dB to 0 dB.
Dial tone send in seizure (dsend)
This command is used to send dial tone to voice channel after receiving seizure
signal in DTMF signaling.
MAX:/CONFIG/R2>change dsend <value>
The option value can be selected as ‘
on
’ or ‘
off
’.
wait first DTMF timer (fdwt)
This parameter is used to set the time to wait for the first DTMF message after
receiving seizure signal in DTMF signaling. If the first DTMF message is not
received until this timer gets to time out, the call is released.
MAX:/CONFIG/R2>change fdwt <value>
The option value can be selected from 1 second to 30 seconds.
wait second DTMF timer (sdwt)
This parameter is used to set the time to wait for DTMF message for each digit
number after receiving seizure signal and the first DTMF message in DTMF
signaling. the next DTMF message is not received until this timer gets to time out,
the number of the incoming call will be regarded as collected.
