38
NOTIFICATIONS
There are many different alarm notifications you could set on the gateway so that you could receive the
notifications on your phone when different situations happened.
On each Z‐Wave device, the notification could be triggered on the following conditions:
1. Sensors ‐ when it is trigged, like the PIR sensor, flood, smoke, contact sensor. Or when it exceeds a specific range
of values, like temperature, humidity, brightness or even wind speed sensor.
2. Battery devices ‐ could be triggered when battery is lower than a specific percentage.
3. Switches, power plug, color bulb or curtain ‐ could be triggered when on/open or off/close, or when adjusted to
a specific range if the multilevel function is provided for the device.
4. Door lock ‐ could be triggered when it’s locked or unlocked.
To enable and disable notifications, simply tap on the bell icon for the device you like to get the push notification
for.
You can disable all notifications (except for D8/D16 arm/disarm notifications) by
tapping on the bell icon on the main page. This will disable all the notifications
you have enabled throughout the app.
Note:
For the house mode (arm/disarm), the notification is always enabled when the
house mode (arm/disarm) is changed, and cannot be disabled unless you disable
the entire app’s push notification from the phones system settings on your
device from the settings app on it.
Summary of Contents for G1
Page 5: ...5 TYPICAL CONFIGURATION ...
