9
TROUBLESHOOTING
Burner will not ignite when using the igniter:
Cylinder valve is not on
Turn cylinder valve on.
Cylinder is empty
Replace with a full cylinder.
Igniter button is not working
Check connections.
Igniter is not sparking
Remove plate and visually check ignition box for a spark. If there is no spark
contact, check connections.
Injector is blocked
Clean injector with a toothbrush. Do not drill out or use wire. Do not remove
injector. Contact authorised service centre.
Burner flame is erratic:
Burner is blocked
Remove burner and check for obstruction.
Flame is burning inside burner
(hissing sound)
Turn off burner, allow to cool and re-ignite.
Regulator is faulty
Contact authorised service centre.
Injector is partially blocked
Clean injector with a toothbrush. Do not drill out or use wire. Do not remove
injector. Contact authorised service centre.
Gas is leaking from connections:
Connections are loose
Tighten loose connections (do not over-tighten) and leak test under
pressure with soapy water solution. Refer to leak testing instructions
Hose has deteriorated
Replace hose and leak test after replacement.
Gas valve is faulty
Contact an authorised service centre
Threads are damaged
Contact an authorised service centre
Lights not working:
Power not on
Check that the power cord from the power adaptor is connected correctly
and that the power is on at the main power board.
Transformer overheated
Turn off main power for half an hour before re-trying.
Globe(s) broken
Replace globes.
Switch or wiring damaged
Contact Everdure Service.
MAINTENANCE
It is recommended that, at the commencement of each barbecue season, the following maintenance be
conducted.
BURNERS
1.
Remove the burner and inspect the port holes, primary air inlet and mixing throat for any signs of
blockage. Clean out with compressed air or a length of wire if necessary.
2.
Wire brush the outside of the burner to remove rust and dirt.
3.
Replace the burner.
GAS SUPPLY
1. Inspect the gas supply hose for any deterioration and replace it if necessary.
2. Test the gas circuit for leaks and remedy any found.
TROLLEY
1. Check all fasteners for tightness and re-tighten where necessary to ensure rigidity of the structure.
2. Wipe over barbecue trolley with a clean cloth.
