background image

5in. HIGH SPEED 

AIR SANDER/DRILL COMBO

USER'S MANUAL

        WARNING:

Read carefully and understand all INSTRUCTIONS before operating. Failure to follow 
the safety rules and other basic safety precautions may result in serious personal injury.

Item# 1991202

6 of 6

        WARNING

Some dust created by power sanding, sawing, grinding, drilling, and other construction 
activities contains chemicals known to the State of California to cause cancer, birth 
defects or other reproductive harm. Some examples of these chemicals are:
 lead from lead-based paints,
 crystalline silica from bricks and cement and other masonry products, and
 arsenic and chromium from chemically treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. 
To reduce your exposure to these chemicals: work in a well-ventilated area, and work with 
approved safety equipment, such as those dust masks that are specially designed to filter 
out microscopic particles.

Distributed by

Northern Tool + Equipment Co., Inc.

2800 Southcross Drive West

Burnsville, MN 5337-0499

Made in China.

Summary of Contents for 5in. HIGH SPEED

Page 1: ...defects or other reproductive harm Some examples of these chemicals are lead from lead based paints crystalline silica from bricks and cement and other masonry products and arsenic and chromium from chemically treated lumber Your risk from these exposures varies depending on how often you do this type of work To reduce your exposure to these chemicals work in a well ventilated area and work with a...

Page 2: ... from the work surface and release pressure on the TRIGGER to stop the Sander Drill MAINTENANCE Your Sander Drill is best operated with an Airline Oiler If you are using the Sander Drill without an Airline Oiler follow the steps below for maintenance Step 1 Disconnect the Sander Drill from the air hose Step 2 Apply a few drops of PNEUMATIC TOOL OIL through the air line before each use or every hou...

Page 3: ...bber Gasket O Ring Regulator Trigger Pin Pin Housing Lock Ring Bearing Spacer Rear End Plate Description Part Qty 19 20 21 1 23 22 24 25 26 27 28 29 30 31 1 1 1 4 1 1 17 18 1 1 1 1 1 1 1 Cylinder Vanes Rotor Bushing Front End Plate Spacer Bearing Cylinder Housing Sanding Adapter Holding Tool Adapter Lock Down Backing 3 Plate Backing 4 1 2 Plate Backing 5 1 2 Plate Chuck 1 ...

Page 4: ...g repairing or cleaning 11 Remove adjusting keys and wrenches Check that adjusting wrenches are removed from the tool or machine work surface before connecting it to its power source 12 Avoid unintentional starting Be sure the air compressor switch is in the Off position when not in use and before connecting to this tool Do not carry any tool with your finger on the trigger whether it is connected...

Reviews: