User Manual of E Series Network Speed Dome
64
3.
Click
to save the above settings
.
You can click
Test
to make sure that the IP address is valid.
If the DHCP server is available, you can check
to automatically obtain an IP
address and other network settings from that server.
The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 1500. The default value
is 1500.
The Multicast sends a stream to the multicast group address and allows multiple clients to
acquire the stream at the same time by requesting a copy from the multicast group address.
Before utilizing this function, you have to enable the Multicast function of your router and
configure the gateway of the network speed dome.
If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the
Preferred DNS Server
and
Alternate DNS server
.
Figure 6-2
DNS Server Settings
The router must support the route advertisement function if you select
Route
Advertisement
as the IPv6 mode.
Configuring DDNS Settings
Purpose:
If your speed dome is set to use PPPoE as its default network connection, you can use the
Dynamic DNS (DDNS) for network access.
Before you start
:
Registration on the DDNS server is required before configuring the DDNS settings of the speed
dome.
For your privacy and to better protect your system against security risks, we strongly
recommend the use of strong passwords for all functions and network devices. The password
should be something of your own choosing (using a minimum of 8 characters, including
upper case letters, lower case letters, numbers and special characters) in order to increase
the security of your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
Steps:
1.
Enter the DDNS settings interface:
