9
4.5 Replace battery cartridge
1. Please switch off the tool before inserting or removing the battery cartridge.
2. Remove the battery cartridge from the clipper by pressing the buttons on both sides of the
battery cartridge.
(Figure 4)
3. Insert the battery cartridge, and push to the end until it locks in place with a little click. If not, it
may accidentally fall out of the tool, causing injury to you or someone around you.
4. Do not use force when you insert the battery cartridge. If the battery cartridge does not slide
easily, it is not inserted correctly.
5. Battery cartridge is automatically stopped when the output power is low ( output voltage is
less than 12V).
Notice:
We should sure that the tool is switched off and the battery cartridge is removed before
adjusting or checking function on the tool.
4.6 Charging
1. Plug the battery charger into the proper AC voltage source. The charging light will flash as
green color.
2. Take off battery cartridge form clipper body , put it into Battery Charger.
3. As soon as battery cartridge get into Battery Charger the red light of battery charger lighting
4. When the light color transform from red to green, the charging cycle is complete.
5. The battery charger will transform
into its “trickle charge (maintenance charge)” mode when
the battery content is full.
6. After charging, please push out the charger from the power source.
7. The full charge need to last approximately 2 hours.
Notice:
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period of time, it may not accept a full charge. This is a normal condition and it does
not indicate a problem. You can recharge the battery cartridge fully after discharging it
completely and recharging a couple of times.
If you charge a battery cartridge from a just operated tool or a battery cartridge which has
been laid in a location exposed to direct sunlight or heated for a long time, the charging light
may flash in red color. If this condition occurs, please you wait for a while. Please charge until
the battery cartridge cools. The battery cartridge will cool faster if you remove the battery
cartridge from the battery charger.
If the charging light flashes alternately in green and red color, charging is not possible.
Maybe the terminals on the charger or battery cartridge are clogged with dust or the battery
cartridge is worn out or damaged.
4.7 Malfunctions
Please refer to the list of malfunction analysis which is section 7
“Repairs” for the rectification of
malfunctions.
