NED XCM8085DLMT8, User Manual

Page: 27 / 89

27 NED
XCM8085DLMT8 UME-0060-04
The minimum value of VAL2 is specified under the condition of 8tap selection.
（
See more
information on 4.2.20 for Setting Output Tap Number.
）
4.1.5 Memory Setup Values (Factory Settings)
The memory setup values (factory settings) are shown in Table 4-1-5-1.
Table 4-1-5-1 Memory Setup Values (Factory Settings)
Control Item CMD VAL1 VAL2 VAL3 Control Description
Analog Gain gax 0 x1.00
Digital Gain gdx 0 x1.00
Digital Offset odx 0 0
Exposure Mode inm 0 Free Run
Output Tap tap 8 8tap
Display disp 0
0: one display for single line,
dual lines and 2x2 binning
modes
Programmable Exposure
Time
(Setting line A and line B
together)
int 1(fix) 10000 117.6
μs(*1)
Programmable Exposure
Time1 (for line A only)
inta 10000 117.6
μs(*1)
Programmable Exposure
Time2 (for line B only)
intb 10000 117.6
μs(*1)
Test Pattern tpn 0 Off
Pixel Correction Setting shc 1 200
Factory black correction + factory
white correction
Exposure-Readout Time pad 0 2.141
μs
Scanning Direction rev 0 Forward
Line Delay d 0
Line Delay 0(Line Delay setting is
not used)
Output Data Rate Setting clkcl 85 85MHz
Output Signal Setting 1 voa 0 8bit
Output Signal Setting 2 vod 0
Dual Lines Mode (Average)