Necta Samba Top, Installation Operation & Maintenance

Page: 28 / 76

© by N&W GLOBAL VENDING S.p.A.
22
12 2008 3335 00
maNagEmENT of cHaNgE TubES
From this menu you can manually load or empty the
change tubes of the coin mechanism.
tuBE ManaGEMEnt
Tube load
Tube unload
FILL> x.x
loaD tHE tubEs
If you confirm the function, “Credit : ——” will appear on
the display. This is the value of the money made avail -
able in the tubes for the change. If you insert a coin into
the selector, the display will increase the value of the
money made available in the tubes for the change.
uNloaD tHE tubEs
If you confirm the function, you can establish the tube on
which you wish to act.
Whenever you press the Enter key
�
, a coin is ejected
by the active tube.
SPEcial SElEcTioNS
sPECIal sElECtIons
Virtual selections
Virtual price return
two-motor selections
Photocell parameters
FILL> x.x
virtual sElEctioNs
This function is used to define a pair of selections that
can be sold at a price different from the sum of the two
selections, using one single selection number. 10 virtual
selections can be programmed (70 to 79).
virtual pricE rEturN
Use this function if you do not wish to cash the price
of the second selection if the second dispensing cycle
of a virtual selection should fail (only if MDB payment
systems or validators are in use). For the other payment
systems, you can establish whether to return the whole
amount or not.
two
-
motor sElEctioNs
To dispense long products, you can mount the dividers
in order to use two motors for one single selection.
Use this function to combine the operation of two motors
by specifying the selection number and the second mo -
tor.
The first motor number will be the selection number
whereas the selection number of the associated motor
will remain disabled.
important!
after a failure to the motors of these selections, fol-
low the procedure intended to configure the “Spi -
rals/Selections” menu of the machine.
DEtEctioN of tHE DispENsiNg cyclE
The machine can be fitted (as a standard or as an op -
tion according to the models) with a device intended to
detect the passage of dispensed products by means of
photocells.
If no dispensing cycle is detected for a product, this
device will enable you to:
set a rotation time for the spiral beyond the limit switch, -
to overcome any jam;
return the paid amount or not;
-
lock any further selection on the spiral in question. -