Necta Samba Top, Installation Operation & Maintenance

Page: 20 / 76

© by N&W GLOBAL VENDING S.p.A.
14
12 2008 3335 00
chapter 2
iNSTallaTioN
installation and any subsequent maintenance op-
eration must be carried out by the personnel skilled
and trained on the use of the machine as well as
aware of the specific risks such a condition may
involve.
The machine is not suitable for outdoor installation,
it must be installed in a dry room at a temperature
between 5° and 34°C.
The relative humidity shall not exceed 65%
it cannot be installed in a room where water jets are
used for cleaning (e.g. large kitchens, etc.).
The machine shall be arranged in such a way that
the maximum inclination is not exceeding 2°. if nec-
essary, level it by means of the feet.
maiN SWiTcH
A microswitch is assembled in the electric panel (see fig.
20). It is intended to power off the equipment as soon
as you open the slide-in compartment of the payment
systems.
only the parts protected by covers and highlit by the
label “power off before removing the cover” remain live
inside the equipment.
before removing these covers, detach the power
supply cable from the mains.
to power on the installation when the extractable com-
partment is open, just insert the key into the slot of the
compartment switch,.
uNPacKiNg THE VENdiNg macHiNE
After having unpacked the machine, make sure that the
equipment is intact.
In case of doubt never use the equipment.
No packing material (plastic bags, foam polysty -
rene, nails, etc.) should be left within the reach of
children since they are potential sources of danger.
Packing materials shall be disposed of in authorised
dump sites and recyclable ones collected by specialised
companies.
if the vending machine has been laid down during
transportation, wait at least an hour before con-
necting it with the power mains.
PaymENT SySTEm aSSEmbly
The machine is sold without any payment system.
as a consequence, only the installer will be liable
for any damage that may be caused to the machine
or to things and persons by an incorrect installation
of the payment system.
Mount the coin mechanism by paying attention to the fol -
lowing, according to the type of coin mechanism in use:
Lift and turn the coin mechanism support -
Select the most suitable fastening holes; -
Loosen the fastening screw and adjust the coin insert
-
slide according to the coin mechanism entrance;
Loosen the fastening screws and adjust the lever in
- -
tended to open the selector:
Fig 18
Coin slide fastening screw 1-
Coin slide 2-
Selector opening lever 3-
Coin mechanism fastening holes 4-
Openable coin mechanism support 5-
Coin return slide 6-
Coin insert slide 7-